AR 50 Analog
| Stat | |
| Rated voltage | 24Vdc |
| Rated current | 2A(1) |
| Starting current | 5A(1) |
| Power consumption (Max) | 50W |
| Ambient temperature in operation | 0 °C to +40 °C, non-condensing |
| Compatible NDW controllers | Compatible with controllers with an analog interface. E.g BWU3290, BWU2478 and similar. |
| Motor connector type and cable length | M8 5-pin, male, snap-in, B-coded, length 900mm |
| Motor shaft | Stainless steel, 11 mm hexagon, thread M12 x 1.75 |
| Tube | 50 x 1.5mm, stainless steel or zinc-plated steel |
| Stall protection | If motor is stalled for more than 2 seconds, the motor will stop and the error signal will become low. To reset turn the power off and on again. |
| Overvoltage protection / Overcurrent protection | No. Current cap to be provided by controller. Do not use in overload condition, which is higher than 5A for longer than 2 seconds. Overcurrent protection module available separately. See page 7, accessories for article number. |
| Protection rate | IP54 |
| Maximum Noise level | 55 dB(2) |
| Minimum conveyor frame width for E-roller | IL = 275 mm (Poly-v transmission) |
1. Actual current is depended on the conditions of the application, such as actual load, section length, slope etc.
2. Measured at 1 meter. Also dependent on the conditions of the application, such as conveyor frame, mounting type, load and resonance behavior of the system
